Garage door springs offset the weight of the door and allow it to open and close with ease. A problem with the spring tension could cause the door to open or close unevenly, improperly, or at the wrong speed, and adjusting the springs will. This tension makes it easier to lift the garage door from its closed position. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. The problem is that they have to be worked on when the door is down and the springs are under tension.
How to Install Safety Cables On Your Garage Door Spring. They are like torsion springs, but instead use pulleys to create tension when the door closes. Once the spring is free of tension, remove from its track hanger. Adjust the springs on both sides of the door the same way. If you have winding bars and torsion springs on your garage door, you’ll find this video helpful. How To Adjust Your Garage Door Opener’s Travel and Force.
Instructions for replacing a single torsion spring, for replacing garage door extension springs, and for replacing Wayne Dalton Torquemaster springs are linked to our DIY Instructions page above. Replacing garage door torsion springs is dangerous because the springs are under tension. 9.8 Twist the garage door shaft to tighten the cable on the drum. Step-by-step instructions for installing a single torsion spring, shaft, bearing plates, cables and cable drums on a garage door. CAUTION! Replacing garage door torsion springs is dangerous because the springs are under tension. Tighten the nuts to secure the bottom of the plate to the horizontal angle. Garage door springs and parts for the do-it-yourselfer to repair torsion springs and extension springs including Clopay EZ-Set springs, Wayne Dalton Torquemaster springs, mini-warehouse springs, steel rolling door springs, and Holmes One-Piece Springs for residential, commercial and industrial overhead garage doors. You can adjust the spring tension by inserting a winding bar in another hole in the winding wheel, pulling down on the bar, and removing the bolt to free the wheel and shaft to turn.
An annual garage door tune-up helps ensure reliable, quiet operation and safety. Never attempt to adjust or release the tension on an overhead torsion spring. Extension Springs & Torsion Springs – No Drive Up Fee, Risk Free! Open loops, closed loops or clipped ends are used to ensure that extension springs are secured to the garage door pulley, frame, pivot pin, track hang or tension adjusting bolt. Extension springs are found on most traditional roll up garage doors. The tension of the garage door springs can be adjusted by doing the following:. How to adjust garage door torsion springs? Once you have the desired tension, allow the rod to rest against the door header and re-tighten the set screws. WARNING Springs in garage doors are under high tension. Disconnect the garage door from the garage door opener.
How To Replace Garage Door Torsion Springs
Because of the force behind a torsion spring, it is recommended that it is adjusted by a professional only. If your garage door tension spring is side mounted, you should have no problem adjusting it yourself.