How To Balance A Garage Door With A Torsion Spring (DIY Project Download)

Torsion springs when wound up apply a balance of weight to the torsion pole and the pole is attached to 2 cable drums that wind up the cable attached to the bottom of door. A properly balanced garage door is important for several reasons. (locking-pliers) attached to the torsion-tube until you are sure the door is not going to spring up with too much force. Both torsion springs must be adjusted equally to assure balance in the door. 5) Depending on whether you wish to increase the opening force or decrease the opening force of the springs, you must determine the proper direction to turn the collar:.

how to balance a garage door with a torsion spring 2Torsion springs balance the garage door by applying torque to the shaft with drums at each end. Attached to each drum is a cable that extends to and is secured to the bottom fixture at the bottom of the door. Periodic maintenance of your garage door includes balancing to ensure the door opens and closes with maximum efficiency. Stand a stepladder at the front wall to access the torsion rod and tension-spring adjuster at the outer end of the spring. Most two-stall garage doors use torsion springs: these run parallel to and above the door header and are designed to counter the heavier loads of these big doors.

Hello everyone I replaced both torsion springs yesterday, and wound them the 30 quarter turns recommended. The springs are not balanced and the side where the gap occurs needs to be adjusted. The ‘Next’ section discusses ‘Adjusting Garage Door Torsion Springs’. The vast majority of garage doors have either torsion springs, which mount on the header above the door (opening photo), or extension springs, which float above the upper roller track. A properly balanced door is less likely to crush someone or something and keeps your door opener from working too hard.

Garage Door Springs

how to balance a garage door with a torsion spring 3Please note: adjusting a garage door with torsion springs can be a dangerous affair, so contact your local garage door installer if you feel in the least bit nervous about performing this task. Note that because the garage door will be down, this will mean: 18 The springs will be under tension, which increases the risk of injury. Torsion springs must be adjusted equally to ensure balance. Replacing broken torsion springs on a garage door. A Garage Door uses a spring system to counter balance the weight of the garage door. In a sectional torsion spring system this is done using one or more torsion. A typical overhead garage door consists of several panels hinged together that roll along a system of tracks guided by rollers. The weight of the door is balanced by either a torsion spring system or a pair of extension springs. The 2-spring system will make your springs last longer since it balance the weight on two instead of just one spring.

Garage Door Torsion Springs

How to balance a garage door with a torsion spring. These instructions outline regular garage door maintenance steps. Torsion springs are round springs mounted under high tension above the garage door. Also, the owner’s manual may offer safe procedures for balancing the garage door. A torsion spring is a spring that works by torsion or twisting; that is, a flexible elastic object that stores mechanical energy when it is twisted. Other uses are in the large, coiled torsion springs used to counterbalance the weight of garage doors, and a similar system is used to assist in opening the trunk (boot) cover on some sedans. How to Install Safety Cables On Your Garage Door Spring. Also, mixing a new spring with an old one can upset the door’s balance in a way that is difficult to correct.

OVERHEAD garage doors that roll up in hinged sections or panels are far more popular than the one-piece, canopy-type doors, even though one-piece doors are generally cheaper. If the door is properly balanced and the springs properly adjusted, you should be able to lift it about three feet off the ground and let go. This type of torsion spring is under extremely high tension and must be wound up (when necessary to increase tension) by using a heavy metal bar that fits into a hole in one end of the spring barrel. Garage doors are typically balanced either by torsion springs or extension springs. Torsion springs are usually mounted above a closed door, parallel and horizontal to the top section of the door. Torsion springs should be replaced by a skilled installer.